Gases under pressure: Compressed gas

Flammable gases, Category 1A, Flammable gas

Acute toxicity - Category 3, Inhalation

Hazardous to the aquatic environment, short-term (Acute) - Category Acute 1

Hazardous to the aquatic environment, long-term (Chronic) - Category Chronic 1

H220 Extremely flammable gas

H280 Contains gas under pressure; may explode if heated

H331 Toxic if inhaled

H410 Very toxic to aquatic life with long lasting effects

P210 Keep away from heat/sparks/open flames/hot surfaces. — No smoking.

P261 Avoid breathing dust/fume/gas/mist/vapours/spray.

P273 Avoid release to the environment.

P311 Call a POISON CENTER or doctor/physician.

P410+P403 Protect from sunlight. Store in a well-ventilated place.

P501 Dispose of contents/container to..…

P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.

P261 Avoid breathing dust/fume/gas/mist/vapours/spray.

P271 Use only outdoors or in a well-ventilated area.

P273 Avoid release to the environment.

P377 Leaking gas fire: Do not extinguish, unless leak can be stopped safely.

P381 In case of leakage, eliminate all ignition sources.

P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.

P316 Get emergency medical help immediately.

P321 Specific treatment (see ... on this label).

P391 Collect spillage.

P410+P403 Protect from sunlight. Store in a well-ventilated place.

P403 Store in a well-ventilated place.

P403+P233 Store in a well-ventilated place. Keep container tightly closed.

P405 Store locked up.

P501 Dispose of contents/container to an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal.

no data available

Fresh air, rest. Artificial respiration may be needed. Refer for medical attention.

Remove contaminated clothes. Refer for medical attention . ON FROSTBITE: rinse with plenty of water, do NOT remove clothes.

First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.

Rinse mouth with water. Do not induce vomiting. Never give anything by mouth to an unconscious person. Call a doctor or Poison Control Center immediately.

Can cause death by respiratory paralysis. It is an eye and respiratory tract irritant. Exposure results in pulmonary edema and hepatic and renal damage. (EPA, 1998)

Immediate first aid: Ensure that adequate decontamination has been carried out. If patient is not breathing, start artificial respiration, preferably with a demand-valve resuscitator, bag-valve-mask device, or pocket mask, as trained. Perform CPR as necessary. Immediately flush contaminated eyes with gently flowing water. Do not induce vomiting. If vomiting occurs, lean patient forward or place on left side (head-down position, if possible) to maintain an open airway and prevent aspiration. Keep patient quiet and maintain normal body temperature. Obtain medical attention. Sulfur and related compounds

Stop flow of gas before extinguishing fire. Use water spray to control fire by preventing its spread and absorbing some of its heat.

Combustion produces irritating sulfur dioxide. Flash back along vapor track may occur. Very dangerous when exposed to heat, flame, or oxidizers. On decomposition it emits highly toxic fumes of sulfur oxides. It will react with water, steam or acids to produce toxic and flammable vapors; and can react vigorously with oxidizing materials. Irritating sulfur dioxide is produced upon combustion. When heated to decomposition, it emits highly toxic fumes and flammable vapors. Incompatible with mercuric oxide and oxidizing materials. Avoid direct sunlight, and areas of high fire hazards. Hazardous polymerization may not occur. (EPA, 1998)

Shut off supply; if not possible and no risk to surroundings, let the fire burn itself out. In other cases extinguish with powder, carbon dioxide. In case of fire: keep cylinder cool by spraying with water.

Evacuate danger area! Consult an expert! Personal protection: self-contained breathing apparatus. Ventilation. Do NOT let this chemical enter the environment.

Evacuate danger area! Consult an expert! Personal protection: self-contained breathing apparatus. Ventilation. Do NOT let this chemical enter the environment.

Stop or control the leak, if this can be done with undue risk. Use water spray to cool and disperse vapors, protect personnel, and dilute spills to form nonflammable mixtures. Control runoff and isolate discharged material for proper disposal.

NO open flames, NO sparks and NO smoking. Closed system, ventilation, explosion-proof electrical equipment and lighting. Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.

Fireproof. Separated from strong oxidants and acids. Cool. Store in an area without drain or sewer access.Separate from oxidizing materials. Store in a cool, dry, well-ventilated location.

TLV: 0.5 ppm as TWA.MAK: 1.0 mg/m3, 0.5 ppm; peak limitation category: II(2); pregnancy risk group: D

no data available

Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.

Wear safety goggles or eye protection in combination with breathing protection.

Cold-insulating gloves.

Use ventilation, local exhaust or breathing protection.

no data available

Decomposes on burning. This produces toxic fumes including sulfur oxides and hydrogen sulfide. Reacts violently with strong oxidants. Reacts with water, steam and acids. This produces flammable and toxic gas.

no data available

Very dangerous, when exposed to heat, flame; can react vigorously with oxidizing materials.The gas is heavier than air and may travel along the ground; distant ignition possible.METHYL MERCAPTAN is a reducing agent--can react vigorously with oxidizing agents. Dangerous fire or explosion hazard when exposed to heat, flame, sparks or strong oxidizing agents (e.g., calcium hypochlorite). When heating to decomposition emits highly toxic fumes of oxides of sulfur [Lewis, 3rd ed., 1993, p. 862]. Violent reaction with mercury(II) oxide [Klason P., Ber., 1887, 20, p. 3410].

no data available

Can react dangerously with strong oxidizing agents and mercury (II) oxide.

Upon decomposition, emits highly toxic fumes of /sulfur oxides/.

no data available

no data available

no data available

no data available

no data available

no data available

The substance is irritating to the eyes and respiratory tract. The substance may cause effects on the central nervous system. This may result in respiratory depression. Exposure at high levels could cause unconsciousness. Exposure at high levels could cause death. The effects may be delayed. Medical observation is indicated.

no data available

A harmful concentration of this gas in the air will be reached very quickly on loss of containment.

AEROBIC: Aerobic degradation of methyl mercaptan is insignificant compared to anaerobic degradation(1).

An estimated BCF of 3 was calculated in fish for methyl mercaptan(SRC), using an estimated log Kow of 0.78(1) and a regression-derived equation(1). According to a classification scheme(2, this BCF suggests the potential for bioconcentration in aquatic organisms is low(SRC).

Using a structure estimation method based on molecular connectivity indices(1), the Koc of methyl mercaptan can be estimated to be 13(SRC). According to a classification scheme(2), this estimated Koc value suggests that methyl mercaptan is expected to have very high mobility in soil. Gaseous methyl mercaptan has been observed to partition to soils(3). For example, when gaseous methyl mercaptan was passed over six air-dried and moist (50% field capacity) soils, 2.4-32.1 mg/g and 2.2-21.4 mg/g of methyl mercaptan rapidly adsorbed to the dry and moist soils, respectively(3). Neither the capacity or rate of sorption was correlated to soil pH, organic matter content, or clay content; sterile controls ruled out the involvement of microorganisms(3); it was suggested that adsorption to soil surfaces might be an environmental sink for gaseous methyl mercaptan(3).

no data available

The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.

Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.

ADR/RID: UN1064 (For reference only, please check.)

IMDG: UN1064 (For reference only, please check.)

IATA: UN1064 (For reference only, please check.)

ADR/RID: METHYL MERCAPTAN (For reference only, please check.)

IMDG: METHYL MERCAPTAN (For reference only, please check.)

IATA: METHYL MERCAPTAN (For reference only, please check.)

ADR/RID: 2.3 (For reference only, please check.)

IMDG: 2.3 (For reference only, please check.)

IATA: 2.3 (For reference only, please check.)

ADR/RID: (For reference only, please check.)

IMDG: (For reference only, please check.)

IATA: (For reference only, please check.)

ADR/RID: Yes

IMDG: Yes

IATA: Yes

no data available

no data available

Turn leaking cylinder with the leak up to prevent escape of gas in liquid state.