Identification | Back Directory | [Name]
methyl(2,3,3-trimethyltrinorbornan-2-yl)amine | [CAS]
60-40-2 | [Synonyms]
Mekamine Mecamine Mevasine Revetina Plegangin Revertina MECAMYLAMINE BASE N-Methyl-2-isocamphanamine N,2,3,3-Tetramethyl-2-norbornanamine N,2,3,3-Tetramethyl-2-norcamphanamine 2-Methylamino-2,3,3-trimethylnorbornane methyl-(2,3,3-trimethylnorbornan-2-yl)amine methyl(2,3,3-trimethyltrinorbornan-2-yl)amine N,5,6,6-tetramethylbicyclo[2.2.1]heptan-5-amine N,2,2,3-tetramethylbicyclo[2.2.1]heptan-3-amine Bicyclo[2.2.1]heptan-2-amine, N,2,3,3-tetramethyl- methyl(2,3,3-trimethyltrinorbornan-2-yl)amine USP/EP/BP | [EINECS(EC#)]
200-476-1 | [Molecular Formula]
C11H21N | [MOL File]
60-40-2.mol | [Molecular Weight]
167.29 |
Hazard Information | Back Directory | [Originator]
Inversine ,MSD ,US ,1956 | [Uses]
Antihypertensive. | [Definition]
ChEBI: Mecamylamine is a primary aliphatic amine. | [Manufacturing Process]
Preparation of 2-(N-Formylamino)Isocamphane: Into a 5-liter 3-necked round bottom flask equipped with stirrer, dropping funnel and thermometer, was added 325 ml of glacial acetic acid. Then, portionwise, a total of 133 g of sodium cyanide (granular, 2.6 mols) was added with stirring while holding the temperature at 15°C. To the thick white slurry was added dropwise a previously prepared cold mixture of 325 ml glacial acetic acid and 360 ml concentrated sulfuric acid. After addition of a few milliliters at 15°C, the thick slurry thins slowly and the
remainder of the sulfuric-glacial acetic acid mixture was added at 0° to 2°C. A
total of about 2 hours was required for the addition. After addition, stirring
was continued for 15 minutes, Then dropwise, over an hour, a solution of 178
g (1.3 mold of dl-camphene in 50 ml of glacial acetic acid was added while
keeping the temperature at about 0°C (±3°C). Stirring was continued for two hours at 0°C during which time a slight
pinkish-yellow color developed in the reaction mixture. The cooling bath was removed and the temperature allowed to rise to 15° to 20°C in about 2 to 3
hours. The ice bath was then re placed and while holding the temperature at
about 20°C, the mixture was gradually diluted with 3 liters of water while
stirring vigorously. After an hour or two of good agitation at room
temperature, the oily product was extracted with 2 x 500 ml and 1 x 200 ml
of chloroform and the combined extracts washed with 2 x 500 ml of water.
The chloroform extract was then rendered neutral by stirring with 500 ml
water and gradually adding solid sodium bicarbonate to the mixture until the
aqueous phase had a pH of about 7; required, approximately 88 g of NaHCO3.
After separation the chloroform layer was washed with 2 x 500 ml water, dried
over calcium chloride, and after filtration the solvent was removed in vacuo on
the steam bath. A solid somewhat sticky residue of 231.2 g was obtained.
After removal of last traces of chloroform by repeated swishing with petroleum
ether, the cake was finally refluxed with about 500 ml petroleum ether (BP
30° to 60°C) until a thick crystalline slurry was obtained. After refrigeration
for a day, the white crystalline mass was filtered by suction, washed with
petroleum ether (2 x 125 ml), then n-heptane (2 x 125 ml) and again with
petroleum ether (2 x 125 ml). After air drying at room temperature to
constant weight, 180.6 g of the dl-2-(N-formylamino)isocamphane melting at
160° to 165°C was obtained. The combined petroleum ether and n-heptane washes were concentrated
under diminished pressure and the residual oil dissolved in a minimum
amount of hot petroleum ether (about 75 ml). The resulting solution was
placed in the refrigerator for two days. The precipitated dl-2-(N-formylamino)
isocamphane was then recovered by filtration and washed with petroleum
ether and n-heptane as described above. Obtained, 12.6 g of product having a
MP of 158° to 164°C. The dl-2-(N-formylamino)isocamphane (193 g) was dissolved in 1.9 liters nheptane by heating on a steam bath, After clarifying the solution by filtration,
the clear filtrate was allowed to stand at room temperature until crystallization
was complete. The crystalline product is filtered by suction, washed with a
little cold n-heptane and air dried. The dl-2-(N-formylamino)isocamphane
melted at 169° to 174°C. Preparation of 2-(N-Methylamino)Isocamphane: To 4.23 liters of anhydrous
ether in a 12-liter 3-necked flask fitted with a stirrer, reflux condenser and
dropping funnel was quickly added 78 g (2.05 mols) of lithium aluminum
hydride. The mixture was gently refluxed with stirring until all hydride had
dissolved which required several hours. A solution of 168 g (0.92 mol) of dl-2-(N-formylamino)isocamphane, prepared
as described above, in 1.81 liters of anhydrous ether was then added during a
period of about one hour with stirring. After addition, the mixture was
refluxed for about 6 hours after which it was cooled slightly and 347 ml of
water added with stirring, hydrogen gas being evolved during the addition,
Stirring was continued until the precipitate changed to a powder, which was
filtered by suction and washed with ether (a total of about 2 liters). The combined filtrate and washes were concentrated to 1.6 liters and the
concentrate containing the dl-2-(N-methylamino)isocamphane washed once
with about 350 cc water, and then dried over anhydrous sodium sulfate. The
dried ether concentrate was then cooled in an ice bath and with stirring a cold
saturated ethereal-hydrogen chloride solution was added slowly until acid to
Congo red; required, about 440 ml anhydrous ether saturated (at 0°C) with
HCl gas, After precipitation was complete, the white crystalline dl-2-(Nmethylamino)isocamphane hydrochloride was filtered, and washed with
anhydrous ether (about 1 liter) until the washes were neutral. The dl-2-(Nmethylamino)isocamphane hydrochloride was air dried at room temperature.
Obtained, 156.5 g of product melting with decomposition at 249°C. | [Therapeutic Function]
Antihypertensive |
|
Company Name: |
AMRI ITALY SRL
|
Tel: |
1.518.512.2000 |
Website: |
www.amriglobal.com |
Company Name: |
Alfa Chemistry
|
Tel: |
+1 (201) 478-8534 |
Website: |
www.alfa-chemistry.com |
Company Name: |
Ambinter
|
Tel: |
+33 (1) 4524-4860 |
Website: |
www.ambinter.com |
Company Name: |
Leancare Ltd.
|
Tel: |
+33 962096793 |
Website: |
www.leancare.co.uk |
Company Name: |
MOLEKULA Ltd.
|
Tel: |
+44 (0) 1747 831066 |
Website: |
www.molekula.co.uk |
|